LABEC AA-17BS - Manual (Page 10)

RUNYES
-Created by love
Please Sel. a cycle
5.Operation
Fig5-1
Operation manual
SEA Series Steam Sterilizers
6
5.1 Turn on the autoclave
Please connect the power cord before you start the operation. Turn on
the autoclave via the ON / OFF switch located behind the small door at
the bottom right of the front of the machine. The power switch light
turns on indicating that electric power is connected.
1 s later, enter to ready to work state after automatically examine.
The screen will display as (Fig 5-1) show.
Fig5-2
134-B-4Min-10Min
Notice
Refilling
5.2 Filling Water / Refilling
Turn on the power switch, select cycle and press OK key. If the water level is lower than the minimum
required, the display will show the refilling page layout (See Fig 5-2) with alarm sounding.
You should add water. Open the tank cover at the top of autoclave and remove the filler filter. Fill tank
with distilled water to cover the GREEN rod.
1. Distilled water will prolong the life of the autoclave.
2. Do not tilt the autoclave when there is water in the water reservoir.
The used water tank should be emptied frequently. You should empty the used water
reservoir when the clean water reservoir is refilled via the used water outlet located
below the ON/OFF switch Caution