Keri Systems HPP–22 - Manual (Page 7)

HPP–22: Hand Held Programmer
2305 Bering Drive 01831-003 Rev. C
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 7 of 10
HPP–22
Quick S
tart Guide
4.5 Enrolling One Card or a Group of Cards
The user assigns a slot number into which the card is enrolled. There are 500 slots available - 1 to 500. The SM-1000
will not allow one card to be enrolled into two slots, nor will it allow a card to be enrolled into a slot already occupied
by another card. Cards enrolled in a group will be assigned sequential slot numbers beginning with the slot number
assigned to the first card.
1. Enter the PIN and press [#]. The LED changes to blinking Amber indicating that the SM-1000 is in programming
mode.
2. Press [1]. The LED changes to steady Green.
3. Enter the slot number to be assigned to the card [nnn] (1 to 500) and press [#]. You can enter one, two, or three
digits as needed. A valid slot entry is confirmed with three BEEPs and three Green LED flashes, then the LED
changes to blinking Green.
4. Present the card to the reader. There is one BEEP to acknowledge the card read. A valid card enrollment is
confirmed with four BEEPs, four Green LED flashes, a Red LED flash, and then the LED returns to blinking
Green.
5. Repeat Step 4 for each card to be enrolled.
6. Press [#] to exit enrollment mode. There are two BEEPs and a Red LED flash, then the LED returns to blinking
Amber indicating that the SM-1000 is still in programming mode.
7. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber.
NOTE: When enrolling cards, if an invalid slot number is entered or an invalid card is presented, the reader BEEPs
once and the LED flashes Red indicating enrollment mode has been exited. The LED returns to blinking Amber
indicating that the SM-1000 is back in programming mode.
4.6 Erasing a Card or a Group of Cards from Memory
1. Enter the PIN and press [#]. The LED changes to blinking Amber indicating that the SM-1000 is in programming
mode.
2. Press [9]. The LED changes to steady Red.
3. Enter the slot number [nnn] (1 to 500) for the card to be erased and press [#]. You can enter one, two, or three digits
as needed. A valid slot entry is confirmed with three BEEPs and three Green LED flashes, then the LED changes to
blinking Amber indicating the SM-1000 is still in programming mode.
4. If there are more cards to delete, return to step 2.
5. Press [#] to exit programming mode and return to standard operation. The reader BEEPs twice and the LED flashes
Red, then the LED returns to steady Amber.