Keri Systems HPP–22 - Manual (Page 2)

HPP–22: Hand Held Programmer
2305 Bering Drive 01831-003 Rev. C
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 2 of 10
Quick S
tart Guide
HPP–22
When programming, the reader's beeper reflects the IntelliProx's status as follows.
2.1 Programming Notes
• Each time a key is pressed the reader BEEPs and the LED flashes Amber.
• Enter the PIN and press [#] to enter programming mode.
• A continuously blinking Amber LED indicates the IntelliProx is in programming mode.
• Commands to be entered by the user are shown in [BOLD FACE].
• When in programming mode, if a command is not issued within 40 seconds, the IntelliProx automatically exits
programming mode and returns to normal operation.
• When in programming mode, all other operations are locked out by the IntelliProx.
Complete instructions for programming the SM-2000 IntelliProx are given followed by the complete instructions for
programming the SM-1000 IntelliProx.
Tone Meaning
Short BEEP Key–press accepted or Valid Card Read
Two BEEPS Command Entry Error or ‘Clear’ Key
Three BEEPS Command Accepted
Long BEEP Command Rejected
Continuous Beeping Alarm Condition