Kenton Control Freak all versions User Manual
Page 35
At this point you have already set the slider to send MIDI volume (controller #7) on MIDI Channel #1.
Continue as follows to make it also send inverted data on Channel #2.
Press the [––>] key – the display will show:
````COMMAND
``End`of`DATA
Turn the Data Wheel one click to the left - the display will show:
Invert`Data````
Press the [––>] key – the display will show:
````COMMAND
``End`of`DATA
Turn the Data Wheel to the left (anti-clockwise) until the display shows:
Set`MIDI`Chan``2
Press the [––>] key – the display will again show:
````COMMAND
``End`of`DATA
Turn the Data Wheel one click to the right - the display will show:
```Controller
Press the [––>] key – the display will show:
Controller`Numbr
0``Bank`Select
Turn the Data Wheel to the right (clockwise) until the the display shows:
7``Main`Volume
Press the [––>] key – the display will show:
Controller`Value
Data`Val`00h```0
Turn the Data Wheel one click to the left and the display will show
Data`from`Slider
Press the [––>] key – the display will show:
````COMMAND
``End`of`DATA
Press the [STORE] key to save your data
UPDATING`MEMORY
Press the [EXIT] key to go back to
PLAY MODE
CONTROL FREAK
EDITING EXAMPLES
31