Table 5.6, M460ml-spv function leds – Avaya P460 User Manual
Page 43
Chapter 5
Avaya P460 Panels
Avaya P460
Installation and Maintenance Guide
29
Note:
Press both buttons simultaneously for 1.5 seconds to reset the SPV supervisor
module.
Press both switches simultaneously for five seconds to reset the entire switch. Refer
to "M460ML-SPV Left and Right Pushbuttons" on page 31 for full details of reset
options.
Table 5.6 summarizes the meanings of the function LEDs. Certain indications
depend on the specific I/O module port type:
Table 5.6
M460ML-SPV Function LEDs
LED
Description
State
Meaning
LNK
Port status
ON
Port enabled and link OK
OFF
Port disabled or link is not
operating
COL
Collision detection
ON
Collision occurred on line
OFF
No collision or FDX port
Tx
Transmit to line
ON
Data transmitted to the line
OFF
No transmit activity
Rx
Receive from line
ON
Data received from the line
OFF
No receive activity
FDX
Full-/Half-duplex
Indication
ON
Full-duplex mode
For 10/100BASE-T ports when
the link test fails with auto-
negotiation enabled
OFF
Half-duplex mode
FC
Flow Control
ON
Flow Control is active
OFF
Flow Control is disabled
HSpd
Port speed indication
ON
Port
10/100
1000
100 Mbps 1000 Mbps
OFF
Port
10/100
1000
10 Mbps N/A