Canon ImageCLASS MF8050Cn - Manual (Page 109)

6-25
U
sing the F
ax F
unc
tions
NOTE - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Check the settings for the recipient's machine also
The ECM function is available only when the setting for the machine
and recipient's machine are enabled.
Even if the ECM function is enabled
An error may occur due to the telephone line.
When the ECM function is enabled
It may take time to receive documents if a problem occurs with the
telephone line.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
How to display the settings
[ ]
→ → →
→
Settings
(Boldface: Default settings)
Off Does not use the ECM function.
On Uses the ECM function.
Incoming Ring
You can specify whether an incoming call for the external
telephone rings when is set to or
.
You can also specify the number of ringing times.
How to display the settings
[ ]
→ → →
→
Settings
(Boldface: Default settings)
Off The telephone does not ring.
On
Ring Times: 1 to 2 to 99
(times)
The telephone rings.
You can specify the number of ringing
times in .
Remote Receiving
If an external telephone is connected, you can switch to the
fax receiving mode immediately by dialing the ID number for
fax receiving using the dial buttons of the telephone during a
phone call.
How to display the settings
[ ] → → →
→
Settings
(Boldface: Default settings)
Off Disables the remote receiving function.
On
Remote Receive ID:
00 to
25 to 99
(times)
Enables the remote receiving function.
You can specify an ID number for fax receiving in
.
Manual/Auto Switch
You can confi gure the machine so that it starts receiving
documents after ringing for a certain time when Mode> is set to .
How to display the settings
[ ]
→ → →
→
Settings
(Boldface: Default settings)
Off
Does not receive documents
automatically.
On
Incoming Ring Time: 1 to 15
to 99 (seconds)
Starts receiving when the time
specifi ed in has
elapsed.
System settings procedure
Specify the system settings using the following procedure.
This section describes the procedure for changing the setting
for [Send Start Speed] as an example.
OK
Menu
Keys to be used for this operation
1
Press [ ] (Menu).
2
Select with [ ] or [ ], and
then press [OK].
Menu
Printer Settings
Timer Settings
Adjustment/Cleaning
System Settings
3
Select with [ ] or
[ ], and then press [OK].
System Settings
Device Information
Dept. ID Management
Network Settings
Communications Setti