Compaq N1020V - Manual (Page 155)

Removal and Replacement Procedures
Maintenance and Service Guide 5–49
3. Remove the charger board (Section 5.18).
4. Disconnect the speaker cable 1 from the system board
(Figure 5-38).
5. Swing the battery bay support bracket 2 to the right until it
clears the right edge of the speaker assembly.
6. Lift the front edge of the speaker assembly until it rests at an
angle 3.
7. Slide the speaker assembly forward and remove it 4 from the
base enclosure.
Figure 5-38. Removing the Speaker Assembly
Reverse the preceding procedures to install the speaker assembly.