Philips AZ3705 - Manual (Page 4)

General Information Safety Information
m
3
S5‘
General Information
• The typeplate is located at the base of the set.
• Recording is permissible if copyright or other rights
of third parties are not infringed.
1 All unnecessary packaging material has been
omitted. We have done our utmost to make the
packaging easy to separate into three mono-
materials:
- cardboard (box)
- expandable polystyrene (buffer)
- polyethylene (bags, protective foam sheet).
Please observe the local regulations regarding the
disposal of these packaging materials.
2 Your set consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please follow local
regulations on recycling your old set.
3 Do not dispose dead batteries with your household
waste. Dispose batteries according to local
regulations.
Safety information
• Before operating the system, check that the
operating voltage indicated on the typeplate (or the
voltage indication beside the voltage selector) of
your system is identical with the voltage of your
local power supply. If not, please consult your
dealer. The type plate is located at the rear of your
system.
• When the system is switched on, do not move it
around.
• Place the system on a solid base (e.g. a cabinet).
• Place the system in a location with adequate
ventilation to prevent internal heat build-up in your
system.
• Do not expose the system to excessive moisture,
rain, sand or heat sources.
• Under no circumstances should you repair the unit
yourself, as this will invalidate the warranty!
• If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the CD unit
inside the system. Should this occur, the CD player
will not operate normally. Leave the power on for
about one hour with no disc in the unit until normal
playback is possible.
• Electrostatic discharge may cause unexpected
problems. See whether these problems disappear if
you unplug the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the power
supply completely, withdraw the AC power
cord from the wall socket
IMPORTANT
To help ensure the top quality performance and
long-life reliability of the CD portion of your new
Philips purchases, we recommend the following
procedures:
1. When situating this product for use, be sure it is
positioned on a perfectly level surface, and not
tilted to either side, forward or backward.
2. When moving this product from one place to
another, such as from one room to another.
• Use the feature, CD LOCK, to secure the CD tray
before transportation. (See page 16)
• Turn the power off and wait for at least 10
seconds for the CD changer mechanism to reset
itself.
• If operating by AC power, unplug the cord from
the AC outlet.
• Lift the unit by its handle and keep it in a level,
horizontal position while moving.
3. When moving the product from one location to a
second, more remote location:
• Remove all discs from the CD mechanism.
(Transporting this unit with discs loaded inside
can result in disc damage or product
malfunction.)
• Turn the power off and wait for at least 10
seconds for the CD changer mechanism to reset
itself.
• If operating by AC power, unplug the cord from
the AC outlet. Detach the cord and store it in the
battery compartment.
• Take care in transporting the unit and keep it in
a horizontal position.