Philips AZ3705 - Manual (Page 12)

Tuner CD Changer
m
3
ca
Tuning to Preset Stations
• Press PRESET T or A to select the desired preset number.
The preset number, frequency and waveband appear on the
display.'
Improving the RADIO reception
For FM, pull out the telescopic antenna. To improve the FM signal,
incline and turn the antenna. Reduce its length if the signal is too
strong (very close to a transmitter).
For AM (MW), direct the built-in antenna by turning the whole set.
The telescopic antenna is not needed.
Changing the FM/MW tuning grid
For FM Band: change from 50kHz to 100kHz or vice versa
For MW Band; change from 9kHz to 10kHz or vice versa
Changing of tuning grid will erase all previously stored preset stations.
While in TUNER mode, press the BAND button for more than 5
seconds. Display will shows "Gr ¡v 3° or “Gr /s ID".
Note:
GRID 9 indicates that the tuning grid is in step of 50 kHz in FM band or
9 kHz in MW band. GRID 10 indicates that the tuning grid is in step of
100 kHz in FM band or 10 kHz in MW band.
CD Changer
Warning!
1) This set is designed for normal CDs. Therefore, do not use any accessories like disc stabilizer rings or CD
treatment sheets etc., which may damage the changer mechanism.
2) Do not load more than one disc into one tray.
3) When the CD changer is loaded with CD(s), do not turn over or shake the unit as this may jam the
changer mechanism.
4) When moving the set, make sure the POWER is switched off I
12