Philips 27ce7695 - Manual (Page 9)

Low notes 9i (BASS),
Balance L/R,
The settings are indicated on the sound
control display on the A/V tuner
amplifier.
• Press the EXECUTE (D) button.
The changes are now stored in the
memory.
Note: The MONO/STEREO, SPATIAL
STEREO and LOUDNESS settings can
also be stored in the memory as
personal settings.
n
© POWER
u
VIDEO ^
B. Television (monitor and
A/V tuner amplifier
combination)
Switching on monitor (if necessary)
• Press the POWER button.
Important!
in order to watch TV normally with the
monitor in combination with the A/V
tuner amplifier, the CONNECTIONS
switch, under the front flap of the
monitor, should be in the REAR
position and the VIDEO RGB/RGB
switch on the rear of the monitor in the
VIDEO RGB position.
• Press the TUNER VIDEO button.
TV followed by a programme number,
or TV.C with a channel number will be
displayed.
STORE SEARCH EXECUTe
SELECT
PROG. ^
О
STORE SEARCH EXECUTE
SELECT
PROG. ^
О
STORE SEARCH EXECUTE
SELECT
PROG,
О
□
MODE SYSTE»4
tz)
AUDIO F/P VIDEO
e
T DOWN UP 1
Searching for and storing TV
stations in the memory of the
A/V tuner amplifier
Important!
Channel numbers
TV stations transmit prgrammes via TV
channels, indicated by TV.C followed by
a three-digit number (000 to 120).
Programme numbers
You select a TV station by giving your
own number (programme number) to a
TV station. These programme numbers
can be indicated by one-digit or
two-digit numbers (0 to 9 or 00 to 89).
Note: If necessary, place the A/V tuner
amplifier in the programme numbers
mode by pressing the VIDEO C/P
button (TV.C indication must not light
up).
A.
• Press the STORE (A) button.
TV indication starts to flash.
The indication PR followed by a
programme number will flash on the
screen of the monitor.
B.
• Press the SEARCH * (B) button.
TV indication starts to fiash.
The monitor screen changes and
ascending channel numbers appear on
the display of the A/V tuner amplifier.
If a TV station has been located, but the
picture is poor, or it is not the desired
station, continue to search by pressing
the SEARCH (B) button again.
• While you are searching for a station,
the word SEARCH also appears on the
monitor screen.
Green for PAL and NTSC, red for
SECAM.
If no TV station is located, you must
select another system by pressing the
SYSTEM button.
C.
• Once the desired TV station has
been located, select a programme
number.
Press the
T DOWN or UP A button to
select the desired programme number.
Note: You can give 90 TV stations a
programme number (from 00 to 89).
If desired, a name can be
programmed with the TV station.
• Press button A or Z, depending on
the letter or figure to be selected. Once
the right letter has been found:
• Press the ENTER button.
Select the next letter or figure, etc.
Repeat these operations until the name
of the station has been stored.
In this way, a name can be given to a
maximum of 34 TV stations.