Philips 27ce7695 - Manual (Page 11)

Operation
m
^ToWER^
m
A-TU
m
CONNECT
A. Radio in combination with
the remote controi unit
Switching on the A/V tuner amplifier (if
necessary)
• Press the POWER button.
Selecting the radio function on the
remote control unit
• Press the A-TU button.
The A-TU indication appears on the
display of the remote control unit.
• Press the CONNECT O* button.
Indication TU, followed by a programme
number or only the frequency, appears
on the display of the A/V tuner
amplifier.
Programme seiection
Select the desired programme number
(radio station) with the digital buttons.
• First press the button for
programme numbers consisting of two
digits.
• Return to one-digit programme
numbers by pressing the button
again.
If the frequency is indicated, set the
A/V tuner amplifier in the programme
numbers mode by pressing the AUDIO
F/P button or by pressing F/P on the
remote control unit.
Changing the sound
If desired, you can change volume
high notes (g (TREBLE), low notes 9!
(BASS) and balance L/R with the
corresponding buttons on the remote
control unit.
See the indications on the display of
the A/V tuner amplifier.
Green button
After changing sound settings, you can
return to your personal preference.
• Press the green PP button.
□ I
SOUND SELECTION
id*- V
o o
MONO
LOUDNESS OK’OFF
Sound
stereo
During stereo transmissions for the
audio tuner, the indication 00 will
appear on the display, unless the A/V
tuner amplifier has been placed in
mono position with the MONO ON/OFF
button.
If the stereo signals are weak, sound
reproduction is automatically switched
to mono.
SOUND SELECTION
o o
MONO
LOUDNESS ON.OFF
SOUND SELECTION
ld+ V
o o
MONO
LOUDNESS ON.'OFF
■ jV SOUND SELECTION
o o
MONO
LOUDNESS ON.'OFF
Spatial sound with stereo signals
• Press the SPATIAL button on the
remote control unit.
The G® indication on the A/V tuner
amplifier lights up.
• Press the SPATIAL button again to
switch off this effect.
Note: For this, the A/V tuner amplifier
must not be in MONO mode. (If
necessary, press the MONO ON/OFF
button.)
Mono
If the sound is reproduced in stereo,
you can switch back, if desired, to
MONO sound reproduction.
• Press the MONO ON/OFF button.
Loudness
The LOUDNESS button is used for
accentuating the high and low notes.
The indication id appears on the
display of the A/V tuner amplifier.
Muting
• Press the MUTE button.
• Press MUTE again to resume sound
reproduction.
Switching off with the remote
control unit (STANDBY)
• Press the (!) STANDBY button on the
remote control unit.
The (1) indication on the A/V tuner
amplifier lights up.
If the remote control is in the A-TU,
TAPE, AUX.1 or AUX.2 mode, you can
switch the A/V tuner amplifier on again
by pressing the CONNECT O*- button.
Operating the A/V tuner
amplifier without remote
control
It is possibie to operate the most
important radio functions without using
the remote control unit.
AUDIO source selector with TUNER,
TAPE, AUX.1 and AUX.2 buttons.
UP/DOWN for selection of programme
number and VOLUME for sound.
It is also possible to select a radio
station directly.
• Press the AUDIO F/P button.
The frequency will be displayed.
• Select the required frequency (radio
station) using the UP or DOWN button.