Timer setting, To cancel the timer – Philips FW390C User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
¥
iimcK
Timer Setting
• The system can switch on to CD, TUNER
or TAPE mode automatically at a preset
time. It can serve as an alarm to wake
you up. After half an hour from the
preset time, the system will return to
the standby mode if no button is
pressed.
• Before setting the timer, make sure the
clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the tinier will be at
the last setting before the set is
switched to standby mode.
1 Press and hold CLOCK*TIMER for more
than 2 seconds to select timer mode.
— "utf /,?. £?£? AM" or the last set
timer starts flashing. The TIMER flag
flashes.
— The last selected source is lighted
while other available sources are
flashing.
—
, !◄ , ►!, ■" light up.
2 Press CD, TUNER or TAPE to select the
desired source.
3 Press ◄◄ or ►► to set the hour for the
timer to start.
4
Press
N
or
►!
to set the minute for
the timer to start.
5 Press CLOCK*TIMER to store the start
time.
-* The TIMER is now set.
The TIMER flag remains on the
display.
• To exit without storing the setting, press
■
.
• At the preset time, the TIMER will be
activated.
The selected source will be played.
The TIMER flag disappears from the
display.
Notes:
- During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
- If the source selected is TUNER, the last
tuned frequency will be switched on.
- If the source selected is CD, playback
will begin with the first track of the last
selected disc. If the CD trays are empty,
the TUNER will be selected instead.
- If the source selected is TAPE, and if the
preset time is reached during high
speed dubbing, the TUNER will be
selected instead.
To cancel the TIMER
1 Press CLOCK*TIMER for more than 2
seconds.
2 Press ■ to cancel the timer.
— "EnuEEi" will be displayed.
— The TIMER flag disappears from the
display.
To start the TIMER again {for the same
time)
1 Press CLOCK*TIMER for more than 2
seconds.
2 Press CLOCK*TIMER again to store the
start time and the selected source.
2
: