Philips FW390C - Manual (Page 14)

OPERATING THE SYSTEM
Important:
Before you begin operating the
system, complete the preparation
procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system. When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
- During the demonstration, if you press
any source (or standby-onj button, the
system will switch to the respective
mode (or standby).
- When the system is switched to standby
mode, the demonstration will resume 5
seconds later.
To stop the demonstration mode
• Press and hold STOP*CLEAR ■ (on
the system only) for 5 seconds when
the system is in demonstration mode.
-* The demonstration will stop.
"SCffu Orr" is displayed.
— The system will switch to standby
mode.
Note:
- Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold STOP»CLEAR ■ (on
the system only) for 5 seconds when
the system is in standby mode.
— The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations in a particular band (EM or
AM) automatically.
• Press and hold STANDBY*ON (on the
system only)iof 5 seconds; when the
system is in standby or demonstration
mode.
— TRSEj 5CT" will be displayed and
followed by "TiltJER”.
-* EASY SET will start with the last
active band.
— All available radio stations with
sufficient signal strength will be
stored or until 40 presets are filled.
Notes:
- When EASY SET is used, all previously
stored stations will be erased.
- The last preset station will appear on
the display when EASY SET is
completed.
Switching the system ON
• Press STANDBY»ON (on the system
on/y/CD, TUNER, TAPE orAUX
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
button.
Switching the system to
standby mode
• Press STANDBY*ON again.
The system will switch to standby
mode.
Selecting the Source
• Press the respective source selection
button: CD, TUNER, TAPE or AUX
—• The display indicates the selected
source.
Note:
- Eor an external source, make sure that
you have connected the audio left and
right OUT terminals of the external
equipment (TV. VCR. Laser Disc or DVD
player) to the AUX IN terminals.
Sound Control
Volume Adjustment
Adjust VOLUME to increase or decrease
the sound level.
Eor Personal Listening
Connect the headphones plug to the .Q
socket at the front of the system. The
speakers will be muted.
14