Philips FW390C - Manual (Page 20)

I Art Hiil AUX
Tape Playback
1 Press TAPE (TAPE 1* *2) to select TAPE
mode.
- "TRPE I" or "TRPC P" will be
displayed,
• Press TAPE (TAPE 1 «2) again to select
either tape deck 1 or tape deck 2.
2 Load the tape into the selected tape
deck.
3 Press PLAY ► to start playback.
3a (For Tape Deck 2 only)
Press A. REPLAY to select the different
type of play mode (see auto replay).
4 Press ■ to end playback.
Note:
- When the tape has stopped playing, the
system will switch to the standby mode
automatically after 15 minutes if no
button is pressed.
Auto Replay (only on tape deck2)
• Press A. REPLAY to select either
continuous AUTO REPLAY or ONCE
during tape playback.
- "RUTS PCPLRT or "ONCE" will
be displayed.
Notes:
- This feature is available during tape
playback only.
- When'fluTu REPTR'-J"is selected,
the tape will rewind automatically at
the end of playback for the selected
side. Then it will start playing again. It
will replay up to a maximum of 20 times
or when you press M.
- When uREE" is selected, the tape will
play the selected side once and then
stop.
Rewind/Fast Forward (only on
tape deck 2)
At the stop mode
1 You can rewind or fast forward the tape
by pressing ◄◄ or ►► respectively.
-* "«<" or "»>" will be displayed
depending on which button is
pressed.
-* The tape will stop automatically at
the end of the rewinding or fast
forwarding.
2 Press ■ to stop rewind or fast forward.
During playback
• Press and hold ◄◄ or ►► respectively
until the desired passage is located.
During searching, the sound is
reduced to a low volume.
— When you release « or the
tape continues playing.
Notes:
- During rewinding or fast forwarding of a
tape, it is possible to select another
source (e.g. CD, TUNER or AUX).
- Check and tighten slack tape with a
pencil before use. Slack tape may get
jammed or may burst in the mechanism.
- C-120 tape is extremely thin and is
easily deformed or damaged. It is not
recommended for use in this system.
- Store the tapes at room temperature
and do not put them too close to a
magnetic field (for example, a
transformer, TV or loudspeaker boxes).
Selecting External Equipment
If you have connected the audio out
terminals of the external equipment (TV,
VCR, Laser Disc or DVD player) to the AUX
IN terminals, you can hear the enhanced
sound from the system.
• Press AUX to select the external mode.
"R um " will be displayed.
Note:
- All the sound control features (e.g. DSC,
DBB, etc.) are available for selection.
20