IC Realtime 1.3 Megapixel 18X PTZ Network Camera with Up-to 300 ft IR (ICIPMP1808IR) User Manual
Page 31
25
POWER UP
：1
PARAMTER ：OFF
BACK
EXIT
HEATER CONTROL
：AUTO
OPEN TEMPERATURE ：
COLSE TEMPERATURE ：
BACK EXIT
z
RESIZE：It is to adjust the privacy zone size. Move the cursor to current item and use the left/right
button on the keyboard or in the speed dome terminal menu to set .Please continue pressing direction
button to widen or narrow zone size. ← is to narrow the horizontal width and → is to widen the
horizontal width. ↑ is to widen vertical height and ↓ is to narrow the vertical height.
z
SAVE：Here is to save user setup.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
Power Up
Move the cursor to the POWER UP item and then click the confirm button, you can go to the fourth
menu.
• POWER UP: It is to set the PTZ operation when the speed dome boots up. The option includes:
NONE/AUTO/SCAN/PRESET/PATTERN/TOUR and etc. Please use the left/right button to set.
• PARAMTER: Here you can set the serial number of the corresponding operation such as the scan,
preset, pattern, tour. Please use the left/right button to set.
• BACK: Go back to the previous menu.
• EXIT: Log out the system menu.
Menu Password
Move the cursor to the MENU PASSWORD and the click the confirm button to go to the fourth menu.
• PASSWORD: Enable this function here so that you set password is valid. This function is on by
default after you set password.
• SETTING: Click the confirm button to go to the password setup interface. Please use the left/right
button to set the value and then click the confirm button to confirm current option. Move the cursor to
the SAVE button and then click the confirm button to save current setup. Click the BACK button to
go to the previous menu.
• BACK: Go back to the previous menu.
• EXIT: Log out the system menu.
If you have forgot your password. After three times of login failure, system may pop up an 8-digit
internal code. Please contact our technical engineer for help.
Heater Control
Move the cursor to highlight HEATER CONTROL button and then click confirm button. You can go to the 4
th
menu.
PASSWORD ：
SETTING ：
BACK
EXIT
PASSWORD：
1
2 3 4 5
6
7 8 9 0
→ SAVE BACK