IC Realtime 1.3 Megapixel 18X PTZ Network Camera with Up-to 300 ft IR (ICIPMP1808IR) User Manual

Page 25

PRESET NO ：001

TITLE ：PRESET001

SETTING

CALL

BACK EXIT

BACK: Go back to previous menu.

EXIT: Log out system menu.

4.4.4.1 Preset Setup

Move the cursor to PRESET button and then click confirm button to go to set interface.
z

PRESET NO: Please use left/right key to modify preset number. The different protocols support

different preset values.

TITLE：Title text is the label used for you to identify the camera. System will automatically name a title

for the camera.

SETTING: Please input preset number first and then select the monitor zone. Please move the cursor to

setting and click confirm button. The system will pop up a message: PRESET: ***. Here *** means
preset number. And the SETTING column pops up an OK. Now you successfully added a preset.
Please note, you need to enable display preset title function first (Main menu->display setting->preset
title).Repeat the above procedures to set more presets. Once you want to modify a preset, you can
input the preset number you want to modify and then follow the above steps to set the preset. You can
successfully modify a preset content.

CALL: Here is to recall preset. Move the cursor to PRESET NO and then input corresponding preset

value. Then move the cursor to CALL and then click confirm button to go to a preset.

BACK: Go back to previous menu.

EXIT: Log out system menu.

For PELCO protocol user, please refer to the following special functions:
z

Call preset: Call preset 28 or preset 95 to go to dome menu. Call preset 29 or preset 99 to go to scan.

Call preset 24 or preset 81 to go to pattern. Call preset 25 or preset 82 to go to tour. Call preset 30 or
preset 96 to stop scan or pattern. Call preset 31 or preset 83 to begin rotation. Call preset 33 to enable
PTZ 180 degrees rotation. Call preset 34 to set dome position as 0.

Set preset: Set preset 26 or 92 to set scan left limit. Set preset 27 or 93 to set scan right limit. Set

preset 22 or 79 to begin record. Set preset 23 or 80 to stop record.

4.4.4.2 Pan

Move the cursor to PAN button and then click confirm button to go to setup interface.
z

PAN SPEED: Set dome rotation speed. Please use the left/right button on the keyboard or in the speed

dome terminal menu to set.

CALL: Move the cursor to call item and then click confirm button. The dome begins 360 degrees

continuous rotation.

STOP: Highlight stop item and then click confirm button. The dome stops rotation.

BACK: Go back to previous menu.

PAN SPEED ：160

CALL

STOP

BACK EXIT