IC Realtime 1.3 Megapixel 18X PTZ Network Camera with Up-to 300 ft IR (ICIPMP1808IR) User Manual
Page 27
21
When you move the cursor to one tour number, please click confirm button to set the tour. Please use
up/down button to set preset number, dwell time and speed. Use the left/right button to go to the next tour.
Click confirm button you can exit the setup. After you completed the setup, move the cursor to back button
to go to the previous interface.
z
DELETE
TOUR：Here is to delete a tour. Input tour number in TOUR NO and then move the cursor to
DELETE TOUR, click confirm button to delete.
z
CALL: Here is to activate tour. Input tour number in tour NO and highlight CALL, click confirm button to
activate touring.
z
STOP: Here is to terminate touring.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
4.4.4.5 Pattern
Pattern function can memory PTZ operation and camera focus zoom in and zoom out.
From the start position, dome begins auto movement repeatedly.
Move the cursor to PATTERN and click confirm button.
z
PATTERN
NO： Here is to set pattern number. Please click left/right key to configure.
z
PROGRAM START: Here is to memorize pattern starting point. An icon OK pops up in screen to prompt
you system begins memory pattern.
z
PROGRAM
STOP：Here is to set pattern stop point. After all the movement, move the cursor to
PROGRAM STOP and then click confirm button. Now you have set one pattern. System pops up an
icon OK to prompt you system has memories one pattern.
z
CALL：Here is to activate pattern. Input pattern number, move the cursor to CALL and click confirm
button, system begins running pattern.
z
STOP: Here is to stop current pattern. Input pattern number, move the cursor to STOP and click confirm
button. System stops current pattern.
z
BACK: Go back to previous menu.
z
EXIT: Log out system menu.
Note:
z
The dwell time between two orders should be less than one minute, otherwise system will set to default
value as one minute.
z
After click PROGRAM STOP, do not click CALL button before icon
“●” disappears completely.
z
Any manual operation during the pattern procedure will terminate current dome pattern operation.
4.4.4.6 Idle Function
PATTERN NO: ：001
PROGRAM START
PROGRAM STOP
CALL
STOP
BACK EXIT