Heli-Max HMXE0806 - Manual (Page 34)

34
E-BOARD ADJUSTMENTS E-BOARD ADJUSTMENTS
Tail Rotor Extent
This adjustment is factory set to the ideal setting and the setting should not be
changed unless absolutely necessary. The [RUD EXTENT] is used to adjust
the maximum throw of the tail rotor servo. The adjustment procedure consists
of turning the model on, holding full tail rotor stick (left or right) and turning the
adjuster until the servo has reached full travel without binding. Move the tail
rotor stick completely in the opposite direction and verify that the servo does
not bind.
Cyclic Extent
This adjustment is factory set to the ideal setting and the setting should not
be changed unless absolutely necessary. The cyclic extent is used to control
how far the swashplate tilts when left/right or forward/aft cyclic is moved. This
controls the maximum cyclic rate of the model. Keep in mind that the Dual
Rate also reduces the maximum cyclic rate. Increasing the cyclic extent also
increases the sensitivity of the cyclic controls. If you feel that the high rate cyclic
rate is not high enough, then turn the adjustment clockwise to increase the
maximum cyclic extent. If you feel the cyclic extent is too high, then turn the
adjustment counter-clockwise to decrease the maximum cyclic extent.