GTCO MM II 1201 - Users Guide - Manual (Page 51)

MM II 51
Appendix B Changing the Set Up Jumpers
This appendix describes how to change the set up jumpers inside the tablet that control
certain operational defaults:
 Baud rate: 9600 or Autobaud
 Report format: binary or ASCII BCD
 Parity: odd or none
Caution: Performing the procedure described in this appendix is done at your own risk.
We take no responsibility for any damage that could occur.
An alternative to changing the jumpers is to use the Z commands, described in Chapter 4.
In brief, to change the set up jumpers:
1. Disassemble the tablet.
2. Change the jumper caps.
3. Reassemble the tablet.
Disassembling the Tablet
1. Ensure the tablet is turned off and all cables are removed.
2. Turn the tablet upside-down on a clean, smooth surface that will not mar it. The
bottom cover should be facing you.
3. Using a Phillips head screwdriver, remove the three cover screws. (A magnetic
screwdriver is helpful because the screws are recessed.) Lay the screws aside.