GTCO MM II 1201 - Users Guide - Manual (Page 22)

MM II 22
The points issued are:
How to Use Increment Mode
Send the mode command and then the increment value. The increment value is in counts
(of resolution) and can be a decimal whole number from 0 to 95. (The default is zero.) Add
32 (decimal), a required offset, to the desired increment and then convert the sum into
your preferred number base. For example, if the desired increment value is 10 (decimal),
desired increment +32 = increment value in
decimal = increment value
in hexadecimal = increment value
in ASCII
10 +32 = 42 decimal = 2A hexadecimal = ASCII
To disable Increment Mode, set the increment to zero with the ASCII space character (SP).
The length of a count can vary depending on the resolution and measurement system the
tablet is using. Therefore, the increment length can vary: