GTCO Summagraphics ADB Interface - Users Guide - Manual (Page 8)

Summagraphics 8
Plug the other end of the cable into one of the system’s ADB ports. There are two
ports on the keyboard and two ports on the computer.
4. Start the tablet.
Start the tablet as described in its installation guide.
5. Start the computer.
Turn on the computer. The light on the ADB adapter box is lit, indicating that it is
receiving power from the computer. (Although the ADB adapter box contains a
power port, it receives power from the computer directly. The tablet receives its
power from the external power supply.)
At this time, the tablet is working with your computer, but it is in mouse mode. For
it to be in tablet mode, install the tablet driver.
ADB Interface for the Microgrid II
Assemble the tablet as described in its installation guide, except as noted below.
1. Configure Microgrid II.
Using the instructions in the Microgrid II Technical Reference and Installation Guide,
configure the tablet as follows:
 9600 baud
 Even or odd parity
 Two stop bits
 Echo off