GTCO Summagraphics ADB Interface - Users Guide User Manual
Page 6
Summagraphics 6
4. Start the tablet.
5. Start the computer.
Turn on the computer. The light on the ADB adapter box will be lit, indicating that
it’s receiving power from the computer. (Although the ADB adapter box contains a
power port, it receives power from the computer directly. The tablet receives power
from the external power supply.)
At this time, the tablet is working with your computer, but it is in mouse mode. For
it to be in tablet mode, install the tablet driver.
ADB Interface for the Summagraphics LCL
Assemble the tablet as described in its installation guide, except as noted below.
1. Configure Summagraphics LCL.
Using the instructions in the Summagraphics LCL user’s guide, configure the tablet
as follows:
9600 baud
Even or odd parity
Two stop bits
Echo off
Proximity Transmission on, “always transmit”
1000 lpi fixed resolution
Binary format
Stream Mode on
UIOF format
Summagraphics LCL DIP Switch Settings
1
2
3
4
5
6
7
8
Set A
ON
OFF
OFF
ON
ON
ON
OFF
OFF
Set B
OFF
ON
ON
OFF
OFF
ON
OFF
OFF
Set C
ON
ON
OFF
ON
*
*
*
*
*factory set