GTCO Summagrid VII - Users Guide - Manual (Page 29)

Summagrid VII 29
Glossary
Accuracy
The similarity of a distance measured by the tablet with the actual distance. When we
specify that the accuracy of a tablet is
± .010 inches, we mean that every point in the Active
Area is within .010 inches of where it should be.
ASCII
Abbreviation for American Standard Code for Information Interchange.
Baud Rate
Rate of speed that data flows between a host computer and the digitizer. It is the number
of bits transmitted per second. The lower the baud rate, the slower the speed.
Bit
Basic unit of information in the binary system – either 0 or 1.
Button
Switch on the cursor or pen used to input data.
Byte
Group of eight bits that acts as a single unit of information.
Coordinate Pair
Pair of numbers representing a unique point on the digitizer surface, usually the distance
across and up from the tablet origin.
CR
The ASCII Carriage Return character usually added to the end of the X,Y coordinate pairs
sent by the tablet (ASCII formats).
Cursor
1.) Transducer used to select specific points on the tablet surface.
2.) Symbol displayed on the screen marking where the next action will take effect, or
where the next character typed from the keyboard will appear.
Data Bits
Each transmission contains 7 or 8 data bits.