GTCO Summagrid VII - Users Guide - Manual (Page 22)

Summagrid VII 22
Replacing the Cordless Cursor Batteries
The cordless cursor requires two AAA batteries. The average battery life for the cursor
batteries is 2,000 hours.
To replace the batteries:
1. Place the cursor face down in the
palm of your hand. Use a Phillips
screwdriver to remove the two
screws located on the bottom of
the cursor (see figure). Remove
the cursor base.
2. Remove the old batteries from the
battery casings.
3. Place the new batteries in the
casings, matching the polarity of
each battery with the markings on
the connector strips (match + to
+).
4. Reposition the cursor base.
Replace the screws with the
Phillips screwdriver.
NOTE: When you replace the cordless cursor batteries, the cursor will reset to the default
frequency. If you changed the frequency of the cursor before replacing the batteries, you
will need to do so again after replacing the batteries (see the Reducing Monitor
Interference section in Troubleshooting).