GTCO Super L III - Users Guide - Manual (Page 48)

Super L III 48
Programming Example: To Send Version Command and Display Results
This QBASIC program interacts with Super L III in Command Mode. In this example, the
program activates Command Mode, sends the VR command and displays the resulting
firmware version transmitted by the Super L III.
1. Configure Super L III for 9600, N, 8, 1, GTCO ASCII and Point (SuperSet 42).
2. Enter and run this QBASIC program:
CalComp Emulation Commands
Super L III recognizes a subset of the CalComp 3400 command set. Space does not permit
a detailed description of CalComp commands. However, most of the commands in this
subset have equivalent Super L III commands. For further information about the operation
of those commands, please refer to the Super L III command or function description in the
GTCO CalComp by Turning Technologies Super L III Command Summary.
NOTE: CalComp commands must be terminated with a , which is not shown in the
codes listed here. Commands can be strung together by substituting an @ character for
the % sequence after the first command and postponing the until the end of
the multiple command string.