GTCO Super L III - Users Guide - Manual (Page 47)

Super L III 47
Sound Tone
Tone Pause Code: T1
Code: T0
The Sound Tone command allows a remote device to sound the Super L III’s audible alarm.
Tone Pause provides a pause between tones. Tones and pauses are in 0.25 second
intervals. Tone commands are not affected by the Disable Alarm command.
Diagnostic Commands
Transmit Version Number Code: VR
Command causes Super L III to determine and transmit the version number of the
firmware currently installed.
Display Tablet Active Area Size Code: SZ
Super L III automatically determines the size of the attached tablet’s active area when it is
turned on or reset. This command can be used to send the information to another device.
The size is encoded as four digits: two digits representing vertical size in inches followed by
two digits representing horizontal size in inches. For example, the 36” x 48” Super L III
sends the digits 3648 in response to this command.