GTCO Super L III - Users Guide User Manual
Page 23
Super L III 23
Using the Tablet Configuration Utilities
If your application is not represented in the SuperSet Menu and does not have a SuperSet
Code or if a different configuration is required, you can use the Tablet Configuration
Utilities to structure the Super L III. The Tablet Configuration Utilities replace the 24
switches that were associated with older Type 5A Controller and the Custom Configuration
Menu Card used with the Super L II Plus.
Configurations you set up can be stored in any of ten user-definable SuperSet locations
(codes 90 through 99) for recall at a later time. This allows the Super L III to be easily
switched between applications.
To Configure the Super L III with the Tablet Configuration Utilities:
1. Make sure Super L III is plugged into a Serial Port, powered on and all the tablet
drivers have been uninstalled or disabled.
2. Install the Tablet Configuration Utilities from TabletWorks CD, or download them
from
3. After installation is complete, run the Tablet Configuration Utilities from the
Programs list under GTCO CalComp by Turning Technologies TCU.
4. The Tablet Configuration Utilities will begin searching the Serial Ports for a
supported tablet.
a. If the tablet is found, information about the tablet will display under Device
Info near the bottom of the screen.
b. If the tablet is not found, a message will appear under Device Info near the
bottom of the screen.
i. If Wintab files were found, it is possible that the TabletWorks driver
has the Serial Port open.
ii. If the Serial Port is open by another application, it will not be
displayed under System Info. Close any application or uninstall any
driver that is using the Serial Port and select Refresh System Info from
the File dropdown list at the top of the screen. Click on the Serial Port
icon under System Info to search that Serial Port.
5. Once the Super L III has been found on a Serial Port, select Advanced Configuration
from the Options dropdown list at the top of the screen.
a. If Advanced Configuration is not an option, make sure Wintab Compatible
Driver is not listed under Device Info.