GTCO Roll-Up III - Users Guide User Manual
Page 5
Roll-Up III 5
Parts Checklist
Roll-Up III digitizing tablet
Transducer (stylus/pen, 4-button or
16-button cursor)
USB cable
CD-ROM with Windows Drivers and
user’s manual
Accessory case*
Cardboard tube, insert and end
caps*
*Do Not Discard
Optional Equipment
Computer interface cable with 9-pin
connector for serial connection
Power supply – required only for
serial installations
Deluxe travel bag
What You Will Need to Use Roll-Up III
A computer running a Windows operating system with USB port, or an RS-232C
serial communication port. (Serial signal levels must conform to EIA RS-232C
specifications.)
Application software that accepts digitizer input via the Wintab API, or application
software that directly accepts digitizer input via the computer’s RS-232C serial port.
Setting Up Your Roll-Up III
The instructions below describe how to set up your Roll-Up III. Before you begin, please
take a moment to fill out and mail the Warranty Registration Card or register your digitizer
on our website at
Software Configuration
Software drivers provide the communication bridge between your digitizing software
application and the Roll-Up III. You should install only the drivers necessary for the Roll-Up
III to work with your application software. The GTCO CalComp by Turning Technologies-