GTCO Roll-Up III - Users Guide - Manual (Page 33)

Roll-Up III 33
want to save the custom one for later recall, you can assign the configuration to a
special user-definable SuperSet Code.
 To save the configuration temporarily:
Click on the
button on the SuperSet Menu. You will hear four short tones to
indicate you successfully saved the custom configuration. The configuration is
saved in a temporary location, where it will be retained even when the unit is
powered off or reset. However, if another SuperSet Code is entered, this temporary
configuration is lost and cannot be recalled without configuring the Roll-Up III again.
 To save the configuration in a user-definable location:
As indicated in Table 2, the codes 90 through 98 are available as storage locations
for user-defined custom configurations. Simply click on the
button and select a
two-digit number between 90 and 98. Your custom configuration will be saved
under that code number for future recall. You will hear four short tones when you
successfully save the custom configuration. Saved configurations allow you to
switch quickly between applications. Storage locations 90 through 98 retain the
saved configurations even when the Roll-Up III is turned off or reset.
Care and Handling of Roll-Up III
Roll-Up III was designed to be both portable and durable. As with any product, it requires
proper care and handling for reliable operation. By following these recommendations, the
Roll-Up III digitizer will provide you with many years of service:
 Always use Roll-Up III on a flat surface, where no part of the unit is unsupported.
 Before moving the digitizer, disconnect the transducer, interface cable and power
supply, if connected.
 Before moving the digitizer, roll it up. The housing along the side of the digitizer is
designed as a rolling aid and it allows you to easily control the rolling action. (See
the Transporting Roll-Up III section on the next page for specific moving instructions.)
 Do not permanently attach anything to the digitizer.
 Do not use sharp instruments on or near the Roll-Up III to avoid scratching or
cutting it. Cuts in the digitizer will void your warranty.