GTCO DrawingBoard VI - Users Guide - Manual (Page 43)

DrawingBoard VI 43
Run Mode
The digitizer transmits coordinate data points continuously, regardless of the status of the
cursor buttons or the pen tip. This mode is also called Stream by some manufacturers.
Serial Transmission
Data transmission protocol where each bit of the data character is sent one at a time over
a single circuit. This system saves on transmission circuitry, but is usually slower than
parallel transmission.
Stop Bits
One or two stop bits are transmitted with each data byte. They mark a completed
transmission.
Track Mode
The digitizer transmits coordinate data points continuously, but only while the cursor
button or pen tip is depressed. This mode is also called Switch Stream by some
manufacturers.
Transducer
Tool used to digitize; it may be either a cursor or pen.
X Direction
Horizontal direction across the face of the tablet.
Y Direction
Vertical distance up and down the face of the tablet.
Regulatory Statements and Warranty
Radio and Television Interference
The user is cautioned that any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits of a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and