GTCO DrawingBoard VI - Users Guide - Manual (Page 41)

DrawingBoard VI 41
Increment Modes
This mode is used with other operating modes. Data points are sent only if the transducer
has moved the required increment distance in either the X or Y direction and has satisfied
the requirements of the operating mode. These increment distances are set separately for
each axis.
Jitter
Repeatability error of short duration caused by electrical noise.
Key
Portion of the tablet surface available to the user for tablet setup.
Line Feed
Optional character added to the end of an output format that causes the printer to move
to the next line, or causes a line to be added on the display screen.
Line Mode
The tablet sends coordinate data points continuously, while the pen tip or a cursor button
is depressed, and one additional point when the pen tip or cursor button is released.
LPI
Abbreviation for lines per inch. English unit of measurement for resolution measuring the
number of separate, distinguishable locations that may be found within the distance of one
inch.
LPmm
Abbreviation for lines per millimeter. Metric unit of measurement for resolution measuring
the number of separate, distinguishable locations that may be found within the distance of
one millimeter.
Mouse Mode
Operating mode that emulates Microsoft and Mouse Systems mouse drivers. Data
constantly transmits when the cursor or pen is on the drawing area of the tablet.
Operating Mode
The conditions that must be met before the tablet sends information to the computer.