Grant Instruments TC120 Operating Manual - Manual (Page 3)

T100 & TC120 30423 V3
Operating Manual Page 2
www.grantinstruments.com
EN
Contents
Contents
2
1.0 Use of products 4
2.0 How to use this operating manual 4
3.0 Safety information 5
3.1 Safety compliance 5
3.2 Safety symbols 5
3.3 Safety warnings 5
4.0 Operating instructions 6
4.1 Unpacking instructions 6
4.2 Fitting controller to ST baths 6
4.3 Fitting the controller to P baths 7
4.4 Fitting the controller to custom baths 7
4.5 Removing the controller from the bridge plate 8
4.6 Recommended liquids 8
4.7 Installation 9
4.8 Electrical supply 9
4.9 Using accessory cooling (C1G, C2G, CW5) 9
5.0 Operating procedures 10
5.1 Operation 10
5.1.1 Liquid level 10
5.1.2 Operation above 60°C 10
5.1.3 Operation at low temperatures 10
5.1.4 Using the pump (TC120 only) 10
5.1.5 Emptying the ST baths 11
5.1.6 Setting up and switching on 11
5.2 Using the T100 & TC120 12
5.2.1 Product description 12
5.2.2 Product indicators 12
5.2.3 Setting the control temperature 13
5.2.4 Configuring a preset 13
5.2.5 Running a bath preset 13
5.2.6 Completing a calibration 14
5.2.7 Restoring factory calibration settings 15
5.2.8 Adjusting display brightness 15
5.3 Additional features of the TC120 16
5.3.1 Setting the over-temperature thermostat 16
5.3.2 Setting a countdown timer 16
5.3.3 Cancelling the timer 17
5.3.4 Setting a high temperature warning alarm 17
5.3.5 Selecting liquid type 17
6.0 Technical specifications 18
6.1 Operating conditions 18
6.2 Electrical details 18
6.3 Product performance 18
6.4 Bath accessories information 18
7.0 Technical Tips 19
7.1 Which water should you use in your bath? 19
7.2 How to prevent rust in water baths 19
7.3 How to prevent algae and bacteria? 19
8.0 Warranty information 20
9.0 Maintenance and service 20
9.1 Routine Maintenance 20
9.2 Cleaning 20