Grant Instruments TC120 Operating Manual - Manual (Page 8)

30423 V3 T100 & TC120
Page 7 Operating Manual
www.grantinstruments.com
Fit the circulation tray in the base of the tank with the large cut out in the tray underneath
the control unit (ST18, ST26 & ST38 only).
4.3
Fitting the controller to P baths
The T100/TC120 can be fitted to the following plastic baths, P5, P12 and P18:
1. Fit the T100/TC120 through the hole in the bridge plate and align using the locating
threads. Secure using the retaining nuts. Hand tighten only.
2. Add the assembly to the P bath and use the supplied fixing to secure to the rear of
the bath.
4.4
Fitting the controller to custom baths
A clamp can be fitted to the T100/TC120 to allow attachment to a non-Grant bath or
vessel with a wall thickness of up to 30mm. To fit the clamp to the T100/TC120:
1. Place clamp over locating threads on base of T100/TC120. Secure using the
retaining nuts. Hand tighten only.
2. Add clamp rear fixings to secure to rear of T100/TC120.
Take care not to over tighten the clamp to avoid damaging the clamp or vessel
The liquid container on which the unit is mounted must be stable and have the
necessary robustness, mechanical, chemical and heat resistance.
Do not wash the clamp in a dishwasher or clean it with descaler. Do not submerse the
threaded shaft of the clamp. Always dry the threaded shaft and clamp after cleaning.
The threads may be lubricated with a small amount of light machine oil.
1
2
1
2