Parts & assembly sheet – Golden Lighting 8106-363/15L CDB User Manual

Page 3

For Customer Service, contact the place of purchase to arrange for replacement parts.

8. By measuring determine correct number of links

needed for proper hanging height. Use a pair of pliers

to open one link of the Chain (C2) then remove the

excess Chain (C2) and discard it.

9. Use one chain connector(E2) to attach one end of

the chain to the Top loop (D2) and close the chain

connector.

10. Feed the fixture wires through the Chain (every

three links) and pull the wires until taut.

11. Slip Canopy loop collar (B2) over the chain, then

do the same with the canopy (F2).

12. When ready to complete the installation Use the

other chain connector and attach the other end of the

chain to the canopy loop (A2) and close the chain

connector.

13. Make sure the weight of the chandelier is

supported by the chain-not the electrical wire.

* You may now install the fixture.

Fig 3

Note: Complete these remaining steps after the fixture

is hung.

14. Place the Glass Shade (Q) over the Threaded

Socket (P),place the Socket washer (R) over the

threaded socket (P) then secure the Glass Shade (Q)

by threading by the Socket Ring (S) until tight.

15. Install the light bulbs in accordance with the

fixture's specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

Fig 4

PARTS & ASSEMBLY SHEET

Fixture Name: Torbellino 8106-363/15L CDB