Golden Lighting 6005-10 RBZ - Manual (Page 3)

For Dual-Chain Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Lancaster 6005-10 PW/RBZ
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the yellow bag that
holds all parts. Check that all parts are included as shown in the illustration and
parts list.
2. Shut off the power at the circuit breaker and remove old fixture from ceiling,
including the old mounting strap.
3. Thread end of the Nipple (C) into Mounting Strap (D).
4. Place Lock Washer (B) over end of Nipple (C) protruding through Mounting
Strap (D) and thread Hex Nuts (A) onto Nipple until tight.
5. Take this mounting strap assembly and mount to ceiling junction box with
junction box Screws (E). Tighten screw securely with screw driver.
CONNECTING THE WIRES (Fig 2)
9. Attach the power supply wires to the fixture lead wires by connecting BLACK
to BLACK (or SMOOTH) and WHITE to WHITE (or RIBBED).
10. Attach the GROUND wire(GREEN or COPPER) from the Junction Box and
the fixture Ground wire to the green Ground Screw on the Mounting Bracket (D)
or connect both wires together using the correct size of wire connectors.
NOTE: Twist the wires together in the same direction you twist the wire
connector onto the wires.
11. Tuck these wire connections neatly into the Junction Box.
12. Raise Canopy (F) to the ceiling and secure in place by threading the Deco
nut (G)onto the Nipple (C).
13. Install the light bulbs and glass shade as per the fixture assembly sheet.
Fig. 2
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX
AND TEST THE FIXTURE.
Fig. 1
6. Take the canopy and pass over the Canopy loop. approximatly one half of
the canopy loop exterior threads should be exposed. Adjust until desired height
is reached. *the Canopy loop collar should fit snugly on the Canopy loop after
the canopy is installed. Remove Canopy and Canopy lock collar.
7. Assemble the fixture and have an assistant or secure support hold the weight
of the fixture while you complete the wiring connections.
8. Thread the fixture wires and ground wire of the assembled fixture through
one of the the canopy loops and nipple and into the outlet box.
BARE COPPER
(Ground)
GREEN
(Ground)
FIXTURE WIRES
SMOOTH (BLACK)
RIBBED (WHITE)
BLACK
WHITE
HOUSE WIRES
E
D
JUNCTION BOX
(CEILING)
A
C
B
G
H
J
K
F
I
H