Golden Lighting 6005-10 RBZ - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
5. Use Chain connector (H) to attach the top of Chain (I) to
the Canopy loop (A2) and close the chain connector as
shown.
6. Tread the fixtrue wires through the center hole in Canopy
loop.
7. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.
* You may now install the fixture.
2. Use Chain connector (H) to attach the Chain (I) to top
curve of fixture Frame (J) and close the connector as shown.
3. Attach a Chain connector (K) to the top end of the Chain
(J). Repeat steps 1 thru 3 for the second chain.
4. Lace the fixture’s wire through the chain links (I) (every
three links) and pull until taut.
(the wires will run through just one side.)
Fig 2
Note: Complete these remaining steps after the fixture is
hung.
8. Place the Glass Shades (M) over the Threaded Sockets
(L), secure the Glass Shades (M) by threading by the Socket
Rings (O) over the socket washers (N) until tight.
9. Install the light bulbs in accordance with the fixture's
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Fig 3
PARTS & ASSEMBLY SHEET
Fixture Name: Lancaster 6005-10 PW/RBZ
L
M
N
O
G
H
J
K
F
I
H
6005-10 Parts Installation-100916m.xls