Golden Lighting 3071-M3 GG - Manual (Page 2)

PARTS & ASSEMBLY SHEET
Fixture Name: Athena 3071-3P GG
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE (Fig. 2)
2. Measure to determine the correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of Chain (K). Remove and
discard excess Chain (K).
3. Use one Chain Connector (L) to attach one end
of the chain toTop Loop (J) then close the chain
connector.
4. Feed the fixture wires through the chain (every
three links) and pull the wires until taut.
5. Slip Canopy Loop Collar (H) over the chain, then
do the same with Canopy (G).
6. When ready to complete the installation, use the
remaining chain connector to attach the other end
of the chain to Canopy Loop (F). Then close the
chain connector.
7. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
H
F
E
D
A
C
B
L
K
G
J
M
L
K