GME TX3520W - Manual (Page 44)

PA G E 4 I n s t r u c t I o n m A n uA l W 1
Steering Wheel Mount
the steering wheel mount is designed to
clamp on to the steering wheel in a position
where the W1 can be easily reached
without distraction while driving.
temporarily place the W1 into the top
clamp then place the top clamp on the
steering wheel at the preferred location.
rotate the W1 to the desired angle, then
turn the clamp over and secure the W1
using the two screws provided. the clamp has
a number of holes and slots to allow the remote
control to be rotated and secured at almost any angle.
rotate W1 for
desired position
Place the W1 into the clamp
turn the clamp over and secure the
W1 using two screws
Fit the back plate to the rear clamp using the three screws provided. Finally,
reposition the front and rear clamps onto the steering wheel in the chosen
Installation using
adhesive foam
remote control Front clamp
rear clamp
m4 bolts
Installations
using clamp
rear clamp
Back cover
screws