Garelick 31400 OUTBOARD MOTOR CARRIER User Manual
Garelick Accessories for water

Assembly Instructions for:
31400 Motor Carrier
PO Box 8, 644 2
nd
Street
St. Paul Park, MN 55071
Form 12.120
Phone: (651) 459-9795
E-mail:
On the Web:
www.garelick.com
Revision Date: 08/07
TOOLS Required:
Page 1
Hammer
CAUTION: Tubing will crush if over-tightened.
Step 1:
Insert 4 bolts (2 7/8” long) through wood block. Place
upright handle tubes over bolts so handles point UP
and AWAY from each other.
Tightly secure with fasteners.
Step 2:
Slip support brackets on axle attached to U-tube using
large holes.
Step 3:
Place lower ends of handle assembly INSIDE of arms
of the U-tube at holes.
Insert bolts and finger tighten fasteners.
Step 4:
Align holes in support brackets with holes in upright
handle tubes.
NOTE: Support bracket is on the outside of the tubes.
Insert bolts and finger tighten fasteners.
Support Brackets
Axle
U-tube
Upright Handle
Tube
Support Bracket
Fastener