Garelick 99188 BREAKAWAY HINGE HARDWARE - Manual (Page 2)

5. Mark four mounting plate hole locations on your transom
or transom extension bracket using the plate as your
template.
NOTE: It may be necessary to make an external shim to
achieve the proper ascent angle (5 to 10 degrees)
for your ladder. Drill one 11/32" or 3/8" hole
through your transom, noting the angle of the
mounting bracket or mounting substrate hole angle.
These holes are perpendicular to the mounting face
plate, not the transom. When drilling this hole
should be used to insure a proper installation. Place
the mounting substrate and/or the outside bracket
against the boat and loosely mount it with the
hardware that you have selected for proper
installation.
6.Level the bracket, mark and drill the next hole. Check the
ladder for level, make adjustments if necessary and then drill
the other two holes.
7. Put a bead of caulk around the perimeter of the four
mounting holes. Coat your selected 5/16 18 SIS mounting
bolts with anti-seize compound and secure outside
mounting bracket with or without external shim to transom
with four selected washers and locknuts.
Refer to Fig. 1.
8. Tap Roll Pin (03.393) into receiving hole in swing bracket
(08.136). Insert slide lock (50.805) into swing bracket with
round notch facing down. Fasten mounting plate (08.086)
to swing bracket using four cap screws (03.576).
9. Insert swing bracket into outside bracket and through
fasten with 5/16-18 x 3 1 ⁄
2
S/S bolt (03.570) and locknut
(03.339). Push in on bottom of swing bracket and insert
Nylon Bolt (03.568) through outside bracket. Secure with
nylon nut (03.569).
LADDER OPERATION INSTRUCTIONS
1. Always lock the ladder then it is in use with the lock bar.
2. Never operate your boat with the ladder in the “down”
position. Serious injury, or damage to your boat or
ladder may result.
SAFETY GUIDELINES
• No jumping or diving!
• Do not use when motor is running.
• This ladder is designed for boat use only.
• Face ladder when entering boat or water.
• Only one person on the ladder at a time.
Installation Instructions –
99188 Sport/Diver Breakaway Hinge
Form 12.439
FIG. 1