Philips CDC 936 - Manual (Page 21)

TROUBLESHOOTING <@>
If a problem occurs, run through the points listed below before taking your changer in for repair. If the problem remains, try to
clear it by switching the changer off and on again. If this also fails to help, consult your dealer or an Authorized Philips Cervice
Center.
Under no circumstances shouid you repair the changer yourseif, as this wiii invaiidate the warranty!
SYMPTOM POSSIBLE CAUSE REMEDY
- Playback does not start or
interruption of playback.
- The current CD has been loaded
upside down.
- No CDs inserted.
- The current CD is badly scratched or
dirty.
- Moisture has accumulated on the
lens.
• Reload the CD, label side up.
• Insert the CDs, label side up.
• Clean the CD with a soft, lint-free
cloth.
• Leave the CD changer in a warm
environment until the moisture
evaporates.
- Sound skips (at the same part). - The current CD is dirty. • Clean the CD with a soft, lint-free
cloth.
- The current CD skips tracks. - The CD is damaged or dirty. • Replace or clean the CD.
- Playback does not start from the
first track (of the current CD).
- PRG (programme) or SHUFFLE
activated.
• Switch off SHUFFLE or clear
programme.
- No sound or bad sound. - Loose or wrong connections.
- Strong magnetic fields near the CD
changer.
• Check connections.
• Find another place for the unit or
change connections.
- No sound or bad sound on
headphones
- Level control set to - position.
- Headphones jack is dirty.
• Set level control.
• Clean jack.
- Volume is too low. - Sound level has been adjusted too
low with the -VOLUME + keys on
the remote control.
• Adjust sound level.
- Remote control does not function. - Batteries are exhausted. • Replace the batteries.
- Remote control commands are not
properly received.
- The distance between remote
control and CD changer is longer
than 32 ft. (approx. 10 meters).
• Use remote control receiver
EM 2200/2201.
• Reduce the distance between
remote control and CD changer.
O)
c
LU
21