Philips CDC 936 - Manual (Page 13)

PLAYBACK ®
BISPWV '' STOP/CP ' REPEAT'
1 1 1
I-M
PEAK
‘SCAK SEARCH FADER-
1 1 1
£
.¡2
"5)
c
111
ACTIVATING THE FADE- IN AND FADE-OUT FUNCTION
(FADER)_________________________________________________
NOTEI
The FADER function can be used if the changer is connected to
the receiver/amplifier or the system via the ANALOG OUT
output jack or the DIGITAL OUT output jack.
• During play press FADER 24.
- FADER lights up and iinn. starts flashing.
- The sound level will now gradually decrease (FADE OUT),
after which the changer will go into the PAUSE mode.
• Press FADER again.
- ■"I'll starts flashing; play continues and the sound level will
increase again to the originally set level (FADE IN).
Other fade times can be entered in the PRESETS mode. For
this refer to the chapter 'PERSONAL PRESETS'.
SEARCHING FOR THE LOUDEST PASSAGE
(PEAK SEARCH)_________________________________
• In STOP mode, press PEAK SEARCH 23.
- SELECT DISC lights up.
• Select the number of the required CD using DISC SELECT 70
or DISC 6 (on the remote control).
- The CD will now be scanned for the loudest passage (the
peak).
- The display shows the track being scanned and its elapsed
playing time.
- When the loudest passage has been found it will be
repeated continuously (from two seconds before the peak
until two seconds after the peak)
• You can now adjust your recording device.
• You can stop the scan by pressing STOP/CP
17: if you press
PLAY/REPLAY 18, the CD will be played from the beginning.
NOTE!
- When searching for the loudest passage in a programme
(from one or more CDs) there is no need to enter the CD
number(s).
- If you wish to record tracks from different CDs you have to
repeat peak search for each CD.
ADJUSTING THE SOUND LEVEL (-VOLUME +)
NOTE!
- Use the - VOLUME + keys (on the remote control) only if
the changer is connected via the ANALOG OUT output jack
or the DIGITAL OUT output jack to a receiver/amplifier or
HiFi system without \ts own control.
- The setting chosen with - VOLUME + will be cancelled
when the changer is switched off or switched to standby.
• Hold -VOLUME 7 (on the remote control).
- The output signal from the changer will now decrease
gradually.
- The successive steps are shown on the display.
U D L = H U D L E = U D L E - U D L E U D L z U D L _
• Release the key as soon as the required sound level is obtained.
• Hold VOLUME + 7
(on the remote control).
- The output signal will now increase again gradually to the
maximum level.
- The successive steps are shown on the display.
U D L _ U D L z U D L E U D L E - U D L E z U D L E E
Release the key as soon as the required sound level is
obtained.
INSERTING AN EXTRA PAUSE (AUTO SPACE) * •
• Press AUTO SPACE 9.
- AUTOSPACE lights up; during play an extra pause of four
seconds will be inserted between the different tracks.
• Press AUTO SPACE again to delete the extra pause.
Other pause times can be entered in the PRESETS mode.
For this refer to chapter 'PERSONAL PRESETS'.
LISTENING WITH HEADPHONES (PHONES)_____________
• Connect headphones with a V4" (6.3 mm) jack plug to the
PHONES jack 25.
• The sound level is adjusted with the LEVEL control 26.
125 26________
13