Philips CDC 936 - Manual (Page 20)

@) ADDITIONAL INFORMATION
m
3
(Q
MAINTENANCE
The CDs
• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.
• Keep the shiny surface of the disc clean.
Use a soft, lint-free cloth and always wipe
the disc in a straight line from center to
edge.
• Never use cleaning agents for
conventional records.
• Detergents or abrasive cleaning agents
should not be used either.
The changer
• A chamois leather slightly moistened with water is sufficient
for cleaning the changer.
• Do not use cleaning agents containing alcohol, spirits,
ammonia, or abrasives.
RECYCLING
Please observe the local regulations regarding the disposal of
packing materials, exhausted batteries and old equipment.
1. All unnecessary packaging material has been omitted. We
have done our utmost to make the packaging easy
separable into three mono-materials:
- cardboard (box)
- expandable polystyrene (buffer)
- polyethylene (bags, protective foam sheet)
2. Your set consists of materials which can be recycled if dis­
assembled by a specialized company.
3. Do not dispose of exhausted batteries with your household
waste.
Note: Switching off the STAND BY mode overnight will
save energy.
TECHNICAL DATA
Typical Audio Performance
Frequency range;.................................. .................. 2 Hz-20 kHz
Amplitude linearity:.............................. ,0.2 dB (20 Hz - 20 kHz)
Dynamic range:.................................... ............ >100dB (1 kHz)
Signal-to-noise ratio:........................... ............ >100 dB (1 kHz)
Channel separation:............................. ............ >100dB (1 kHz)
Total harmonic distortion;................... ...............- 90 dB (1 kHz)
D/A conversion: Bitstream conversion (256 x oversampling,
1 bit), in differential mode
Audio output level:...............................
Impedance PHONES jack;.................... ................ 8-1000 ohms
Power supply
Main supply voltage and frequency;
see the type plate on the rear of the changer
Power consumption:............................ ..............................<10W
Safety requirements:............................ ................... ULand CSA
Cabinet
Material/finish: ...metal and polystyrene with decorative trim
Dimensions (w x h x d):
................................17'x4 Vs‘x 14 6/8* (435 X 106x380 mm)
Weight;................................................... .15.44 lbs (7 kg) approx.
Specifications are subject to change without notice.
20