Philips CDC 936 - Manual (Page 14)

@> PROGRAMMING
m
3
(Q
STORING A PROGRAMME (PRG)
- By programming the changer you can play up to 30 tracks in any required sequence.
- tULL lights up if you exceed the maximum of 30 tracks.
- h.lRuNG DISC lights up if you select a nonexistent CD number.
- USE 0-3 lights up if you press orK^ 76while programming.
• In STOP mode, press PRG (programme) 3to open the memory.
- SELECT DISC lights up and BBS starts flashing.
• Select the number of the first required CD using DISC SELECT 70 or DISC 6 (on the remote control).
• Key in the required track numbers of the selected CD using the 1-0 digit buttons 2.
- Every track number you enter in this way will be included immediately in the programme.
- The display always shows the number of tracks and the playing time of your programme.
IE HIE
• If you wish to store tracks from another CD, you should first enter the number of the CD.
• Press PRG to quit the PROGRAM mode.
• Press PLAY/REPLAY
78 to play the program.
CHECKING THE PROGRAMME (REVIEW)_________________
• Press REVIEW 73 prior to, during or after programmed play.
- REi-'IEW lights up and all CD and track numbers appear in
the programmed sequence on the display.
- Under TRACK TIME you will see the playing time of each
track.
TMOC
HO PROGRflH will light up if no track numbers have yet been
stored.
With REVIEW you can proceed more rapidly to the next block
of information.
PLAYING THE PROGRAMME (PLAY/REPLAY)______________
• Press PLAY/REPLAY 78.
- Playback starts with the first number of the programme.
The EDIT 74. PRG 3and CLR 4 and PEAK SEARCH 23 buttons
cannot be used during programmed play.
Searching for a particular passage is only possible within the
track being played.
ERASING A PROGRAMME (STOP/CP, CLR or OPEN/CLOSE)
In PLAY mode:
• Press OPEN/CLOSE 77 or STOP/CP 17 (twice).
In STOP mode:
• Press OPEN/CLOSE 77, CLR 4 or STOP/CP 77
- The programme has now been erased.
ERASING A TRACK FROM A PROGRAMME (CLR) •
• Press REVIEW 73 before or after programmed play (STOP
mode).
- All CD and track numbers appear in the programmed
sequence on the display.
• Press CLR (clear) 4 as soon as the number you wish to erase
appears.
- The number has now been erased.
- The display shows the remaining number of tracks and the
remaining programme time for a few seconds.
^3^ 77U£K TOTAl
V ri uoo
NO PROoRRH will light up if no track numbers have yet been
stored.
14