Futaba CGY750 - Manual (Page 12)

12
S WASH B ASIC S ETTING
SWASH BASIC MAP. 3 3
(17) Rotational equalizer [default: off]
This function works to optimize pirouette stability during stationary and forward flight. Press the
DATA [+] or [-] key to turn the function on or off.
(18) Equalizer direction [default: normal]
This function sets the rotational equalizer direction. Setting method: When the CGY750 is in
this mode, the swashplate will tilt on direction and stay that way. Observe the direction of the tilt
relative to the surface on which the model sits. Rotate the model 90 degrees about its mainshaft
clockwise or counterclockwise. The swashplate should remain tilted in the same direction rela-
tive to the surface on which the model sits. Adjust Equa.Dir from NORMAL to REVERSE if need-
ed to keep the swashplate tilt in the same direction as the model is rotated. Correctly setting of
the rotational equalizer is critical for proper flight performance during pirouettes. All linkages from
servos to swashplate should be installed prior to setting direction.
Rrturn to SWASH BASIC MAP. 1/3
Push MODE
+/– key
(16) Pitch high memorizing [default: 1100μS]
This parameter saves the maximum collective pitch point into the CGY750. Move the collective
pitch stick to maximum pitch and push DATA [+] or [-] key. The maximum pitch signal will be saved
to the CGY750. The display shows “!” when the stick is at the saved point. The maximum collective
pitch setting must saved into the CGY750 for F/F mixing and/or linkage compensation to function
correctly.
(15) Pitch zero memorizing [default: 1520μS]
This parameter saves the zero collective pitch point into the CGY750. Move the collective pitch
stick to zero degrees pitch and push DATA [+] or [-] key. The zero degrees pitch signal will be
saved to the CGY750. The display shows “!” when the stick is at the saved point. The zero degrees
pitch setting must saved into the CGY750 for F/F mixing and/or linkage compensation to function
correctly.