Futaba 9VHP - Manual (Page 13)

(1) CURVE
1) Move the cursor to the POINT position with
the cursor key.
2) Select the curve point on the display that you
wish to adjust by using the cur-
sor key. The "Point Cursor" is denoted by a
"+" symbol and will be on the point that is
selected for adjustment.
3) The point number is displayed in ( ). Points
are numbered 1 through 12 from left to right
on the display.
4) Each point can be adjusted up or down with
the program key. The rate setting
for that point is displayed inside the standard
cursor. Extreme precision and versatility in
setting the throttle is made possible.
5) To return to a standard linear response curve,
Adjustable
within
this range.
press the key. The amount actually set, including the trim is
displayed in ( ).
(2) Hovering Throttle
1) Move the cursor to the HOV-TH position and
press the program key.
2) Set the T/C stick at center and move the cur-
sor to the RATE line with the cursor
key.
3) Set the desired throttle servo position at hover
by using the program key.
The rate set by the computer is displayed
inside the standard cursor. The total rate set,
including the amount added or subtracted
with the HOV-TH trim knob is displayed in
( ).
4) To change the throw when the Hovering
Throttle Knob is turned, move the cursor to
the LEVER position with the
cursor key
and set the throw with the pro-
gram keys or the program key.
5) To deactivate the hovering throttle, move the
cursor to the HOV-TH ACT position with the
cursor key and press the
program key.
Return to the THROTTLE mixing screen by
pressing the program key.
NOTE: Throttle mixing cannot be used in the
basic mixing mode.
[39]