Futaba 3PK - Manual (Page 39)

Level LV3 Only Servo View SERVO
DEFINITION: Shows the exact outputs the transmitter is sending to the servos. Allows
for easy testing/experimenting even when receiver and servos are not yet installed.
AVAILABLE FOR: throttle, steering, channel 3.
ADJUSTABILITY: N/A.
INTERACTION: Shows all servo interactions from programming.
DESIRED END RESULT: Confirm programming is having desired result before
radio gear is set up in model.
39
GOAL:
While using LV3:
•
Reassign digital trim 1 to the dual rate
adjustment;
•
Assign dual rate switching to switch 1;
•
Adjust 2nd dual rate to slightly less than
maximum (95%) for quick steering to get
out of tight spots.
(If using LV1 or LV2, first change level
selection, see p. 12.)
Where Next:
STEPS:
Use FUNC-DIAL to assign dual rate to
digital trim 1.
Use FUNC-SW to assign dual rate switching
to switch 1.
Select dual rate.
Test the dual rate adjustment by moving
digital trim 1.
Adjust 2 nd dual rate down to 95%.
Test the 2nd dual rate switch by pressing
switch 1.
Close function and menu.
INPUTS:
9 steps to DT1.
12 steps to D/R.
to D/R 2 nd .
Move digital trim 1 counterclockwise; see
the rate decrease on-screen. (Note that the
rate per click can be adjusted in the
function dial screen.)
to 95.
Press switch 1 (below the wheel) and notice
2nd D/R Rate changes from
OFF to ON, as
primary rate changes from ON to OFF.
Adjust the steering servo’s EPA ( EPA): See p. 18.
Adjust steering channel exponential ( ST-EXP): See p. 20.
Adjust steering servo response speed ( ST-SPEED): See p. 23.
Set up channel 3 control ( CH3): See p. 40.
Set up brake mixing for separate front/rear brakes ( BRAKE-MIX): See p. 42.
Use servo screen to see exactly how dual rates are performing ( SERVO): See below.
GOAL:
View screen after setting up steering dual
rate to confirm switch and dials are
working as planned, while using
LV3.
(If using LV1 or LV2, first change level
selection, see p. 12.)
Where Next:
STEPS:
Set up dual rates.
Select servo display.
Close function and menu.
INPUTS:
See page 38.
Return to function and make adjustments as needed, or complete installation in model.
Holding full right turn, adjust dial to see change in total servo throw, then hold dual
rate switch, and notice change in total throw.