Flintec LDU 78.1 - Manual (Page 32)

LDU 78.1 Technical Manual, Rev. 12 May 2011 Page 32 of 36
8.13.6. TI Averaging Time for Automatic Taring
This command defines the averaging time for the automatic taring. Within this time period the system calculates
an averaged tare value. Default setting: TI = 0 ms.
Master (PC / SPS) sends Slave (LDU XX.X) responds Meaning
TI  T+00000 Request: TI = 0 ms
TI 200
 OK Setup: TI = 200 ms
8.13.7. HT Hold time for Violation of Setpoint Limit
This command defines the hold time for any violation of the setpoint limit. The signal has to exceed the setpoint
limit continuously at least for this time period before a switch event will be initiated (see chapter 8.9 for setpoint
setup). Default setting: HT = 0 ms.
Master (PC / SPS) sends Slave (LDU XX.X) responds Meaning
HT  T+00000 Request: HT = 0 ms
HT 200  OK Setup: HT = 200 ms
Figure: Time plot of a measurement cycle with the re-trigger function