Fleet Engineers INS-03029 User Manual

Master multi-mount installation instructions

Master Multi-Mount Installation Instructions

Installation Sheet #INS-03029

NOTE: These instructions for installing Master Multi-Mount are intended to be a general

guide to help the installer. Because of the large number of possible mounting configurations,

the installer is responsible for the installation design and for providing adequate clearance

around the tire carrier (i.e. tire clearance, trailer clearance, etc.)

This product may not fit all truck models or types of suspensions. Check truck or trailer

manufacturer for suspension travel specifications. Modifications to the brackets and/or the

fenders may be required. Any modifications are at the discretion, responsibility and risk

of the installer.

1) Place a Nord-Lock washer first, then the Master Multi-Mount

casting washer (the side with the bevels facing away from the

bolt head) onto a 5/8” x 6 1/2” bolt.

2) Insert the bolt and assembled washers through the slot in the

Master Multi-Mount, matching the side with the bevels to the

bevels on the washer.

3) Slide the Master Multi-Mount Frame Spacer over the bolt, mak-

ing sure that the serrations of the two parts engage.

NOTE: If additional distance from the frame is needed, it can be

gained by using the 3.5” extension set (part #031-01299)

4) Insert the bolt through the selected hole in the frame, then

install a second Nord-Lock washer and a nut onto the bolt, but

only finger tight.

5) Put a 3/8” lock washer on a 3/8” x 1-1/4” bolt and thread it into

the clamp portion of the Master Mount.

6) Slide the Master Multi-Mount Tube through the clamp. Make

sure that at least 1/8” of the tube protrudes out the other side.

7) Make the desired adjustment for offset and rotational position

of the Master Multi-Mount. Then tighten the bolts to the proper

torque, 180 ft. lbs. for the 5/8” bolt and 236 in. lbs. or 19 ft. lbs.

for the 3/8” bolt.

8) Install an end cap into each end of the Master Multi-Mount tube

per directions supplied.

9) Now you can install the Spray Master fender onto the Master

Multi-Mount.

Installation Sheet # INS-03029 • 3/04 • Rev B 3/05 • Rev C 12/06

Patent

#7,073,804