Fleet Engineers INS-12001 - Manual

3. Once you
have verified
where to cut
the AeroFlap
® ,
use a shear, a
fine tooth saw,
or a hot knife
to cut in the
desired location
to achieve the
correct size for
your application.
The scrap
is 100%
recyclable.
NOTE: These instructions for
installation are intended to be a
general guide to help the installer.
The installer is responsible for the
ultimate installation design. Any
modifications to the product are
at the discretion, responsibility
and risk of the installer.
AeroFlap ® Shortie
Installation Instructions
Installation Sheet #INS-12001
1. Fleet Engineers’ AeroFlap ® is designed to be used
in a shortie application. Molded with an integrated
reinforced shortie mounting location, the AeroFlap
®
can be easily cut down to fit a shortie bracket. The
AeroFlap
® is universal - it doesn’t matter which side you
choose to cut.
Installation Sheet #INS-12001 • 4/12
5. Remove the AeroFlap ® from the bracket, place on a solid
surface and use a drill to make the necessary holes.
2. The first step in cutting your AeroFlap ® down to a
shortie is to verify that the standard cut described in
these instructions will work with your shortie bracket.
Note: in some instances, the AeroFlap
® may need to
be cut in a different location to accommodate your
bracket.
4. After the AeroFlap ® is cut, place into the bracket and
mark the locations of the holes.
6. Once the new holes are drilled into the AeroFlap ® ,
position into your bracket and secure following
manufacturers instructions.
1800 East Keating Ave. • Muskegon, MI 49442
1-231-777-2537 • 1-800-333-7890 • FAX: 1-231-773-5500
Panel Support
Mount
(pre-assembled)
Cutline
Cutline
www.fleetengineers.com